• Peter Lavik

    There is no available content written by Peter Lavik
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Dave Fairfax

    Corners - What type of Joinery or Miter

    Biscuits make complete sense. Thanks for the input guys. I assume that would be the best solution, right?

    Dave Fairfax Today, 10:30 PM Go to last post
    eugene thomas

    used cnc pricing?

    I have latley been checking out getting cnc for my shop. I am thinking will keep my eyes open for used one but not sure how to determin value. I am

    eugene thomas Today, 10:30 PM Go to last post
    Pat Barry

    Modem video camera

    OK - here is an alternative. It costs $20 per month for the dial up service but with that the service provider offers this:
    All customers with

    Pat Barry Today, 10:27 PM Go to last post
    Jim Andrew

    Aget mfg Dustkop pushthrough cyclone?

    There are 2 of these for sale about 100 miles away. 200 each. Did say 3 hp each. Only problem is the 3 phase. Cheapest vfd is about 265 I have found

    Jim Andrew Today, 10:26 PM Go to last post
    Tim Leiter

    Varigrind users

    I use the vari-grind for my bowl gouges and I now use it for some of my spindle gouges. I have the adjustable leg set to instructions I read somewhere

    Tim Leiter Today, 10:23 PM Go to last post
  • Recent Blog Posts