• glenn bradley

    There is no available content written by glenn bradley
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Tom M King

    The Chair is finished

    Very nice indeed! Did you keep up with the number of hours into it?

    Tom M King Today, 8:31 PM Go to last post
    Larry Frank

    Ebony / Were to Buy?

    I think that most of the pieces of ebony that I have seen are waxed. The piece that got was waxed and I used a scrapper to clean it off. It was interesting

    Larry Frank Today, 8:29 PM Go to last post
    Tom M King

    Back Flow Preventer Spitting

    Amazing what you can find videos for now. I fixed our washer and dryer (twice) simply, after watching a few minutes of youtube, found thanks to Google.

    Tom M King Today, 8:29 PM Go to last post
    Lee Tincher

    Chinese Laser X Y axis issue

    There is a red and green LED light on the box. When I turn the machine on it goes from red to green and then stays green no matter what I do.

    Lee Tincher Today, 8:26 PM Go to last post
    Thom Sturgill

    Another back saving project.

    Here's an idea for a tie down:
    Get a long piece of canvas that will fit between the rails. It needs to be about twice as long as the circumference

    Thom Sturgill Today, 8:22 PM Go to last post
  • Recent Blog Posts