For those of you in the US, do you measure using an imperial ruler or tape, or go with metric? Having grown own up with imperial, I can visualize a project that calls for a piece that is 8 inches long, as well as 5 feet 8 inches long. However, having to add something like 2 5/12 inches to 3...Last Post By: Curt Harms Today, 9:08 AM
Well, the Oneway banjo I ordered as an aftermarket upgrade for my G0766 arrived this afternoon. Can I say SWEEEEEEET!!!??? :D:D:D Okay, the thing is really built and just exudes quality! Now, my less than stellar cell phone pics are all I have as I had to try and hold a tape measure with...Last Post By: Brice Rogers Today, 12:00 AM
I'm sure this topic might have a broad range of opinions. Mine are as follows: I'm not sure what the Patriots, and especially Tom Brady, were supposed to have done. I haven't seen anything proven. I saw an article where Joe Namath weighed in on the subject and he wasn't convinced Tom Brady...Last Post By: kevin nee Yesterday, 7:03 PM
This will be a little different this year without a certain someone (KAB) complaining about how bad the Detroit Lions are (and bragging about how good the Michigan State Spartans are) but I thought I'd start a football thread for this year. My teams are the New Orleans Saints and the LSU Tigers...Last Post By: Chris Padilla Yesterday, 4:23 PM
Boy, has this been a learning experience! We're in Punta Gorda now, staying in a vacation rental. We've been here about 1-1/2 months looking for a house to buy. For most of my adult life I've dreamed of retiring to a warm climate, a house with a pool and a dock with a sailboat tied to it...Last Post By: Bruce Wrenn Yesterday, 11:19 PM
I am looking to add a router lift to my shop built router table. I searched through the various posts on SMC as well as read some reviews on the web, but thought getting suggestions direct would be helpful. I have a PC 7518 and love it. My top is a shop built out of double thick 3/4" Baltic...Last Post By: Scott Brandstetter Today, 4:07 AM
Rikon (Votes: 2)
Powermatic (Votes: 9)
Shop Fox (Votes: 2)
So if i get it right, the cleaning procedure is as follow.
After i remove the handle i scrap carefully most rust from the flat surfaces. For the
Put my name in the hat.