Seems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: STUART Robertson Today, 5:38 AMI had the high bid tonight on this Rockwell/Delta 28-350. I've been looking for and bidding on these for the last few years, and I was the back bidder a few times, but this one went for a very good price. My reserve bid was $600. It's possible that there's something terribly wrong with it, but...
Last Post By: Zachary Hoyt Yesterday, 10:39 AMI need a bumper sticker that says 'Nobody on board'. Tesla has opened up the 'self driving' app on newer Tesla's for a free 30 day trial. It is factory installed on all of them, they just don't turn it on unless you pay, which we didn't. All of a sudden there is an octogenarian who cannot...
Last Post By: Bill Dufour Today, 12:22 AMI drive a 2006 Toyota mostly on the highway. It has 90,000 miles with the original brakes. I don't hear any squealing on the brakes and they work fine. What do you think?
Last Post By: Larry Edgerton Today, 7:24 AMA lot of people - myself included - make it a policy to really avoid lending out tools. The list is a really short one of the people I will lend a tool to. What about - borrowing a tool?
Last Post By: Mike Henderson Yesterday, 5:51 PMSure - why not? (Votes: 8)
Never. If I needed something, I'd buy or rent it. (Votes: 8)
Maybe. Depends on the person and the tool. (Votes: 40)
Decoupling with floating fasteners is very important for sound proofing. Lots of insulation and lots of drywall will help a little, decoupling helps a
Maurice Mcmurry Today, 8:47 AMWe were down state last year and saw this on a number of occasions. We finally asked someone what the backstory was. It's a Jeep thing. I didn't understand.
Rob Luter Today, 8:33 AMI have gotten them before and I thank them for renewing it and I don't go to myPP account They give up real easy then
Jerome Stanek Today, 8:32 AMYou don't mention how much you need to build up the shaft. I've done this in the past using a plater. I had some small shafts that experienced fretting
Rob Luter Today, 8:28 AMLate to the party again. Been there, done that too, Jim. Nice save. The cabinet looks really good. FWIW, when I have mis-drilled, I plug the holes with
Grant Wilkinson Today, 8:26 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jerry Thompson Yesterday, 7:24 PM