• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: Ted Phillips Today, 1:43 PM Go to last post
    Keith Outten

    FreeStuff Winner - Premium Woodturning Set

    Thread Starter: Keith Outten

    FreeStuff Drawing from Carter and Son Toolworks The winner is Glenn Clabo. Premium Woodturning Set Includes: 5/8" Bowl gouge: Incredibly strong and sharp, our 5/8" Bowl Gouge offers an enhanced bowl turning experience. Made of M42 High Speed Steel, the tool has a razor edge for clean...

    Last Post By: Keith Outten Yesterday, 10:52 PM Go to last post
    Lasse Hilbrandt

    Which smoothing plane

    Thread Starter: Lasse Hilbrandt

    I know this must be a topic which has been discussed to death over and over again. Nevertheless I need some piece of advise on which smoothing plane to buy. I have Stanley no 7, a LN no 5, and Stanley no. 4. Im not really using the Stanley 4. I find it a bit bulky. I think I need an alround...

    Last Post By: Derek Cohen Today, 1:20 PM Go to last post
    Allen Bookout

    Are these wood prices out of line?

    Thread Starter: Allen Bookout

    I need to find a place to buy good wood. I live about twenty miles north of Fort Myers Florida and Alva Hardwoods east of Fort Myers is about the only supplier around here that I know of. I would think that there would be some suppliers in the Tampa area but if these prices are reasonable I would...

    Last Post By: Kyle Iwamoto Today, 2:09 PM Go to last post
    Roger Chandler

    G0766 - Sounds

    Thread Starter: Roger Chandler

    On one of the other threads I read last night and this morning, there were questions regarding the "sounds" or "noises" that come from the new G0766. I began my third project this morning since receiving my unit. This mornings project was the biggest blank I have put on the lathe so far, and...

    Last Post By: Roger Chandler Today, 10:27 AM Go to last post
    Derek Cohen

    Four down, four to go ..

    Thread Starter: Derek Cohen

    Just a quick update on the Lingerie Chest. Four drawers done. They take 3 full days each to build (1 1/2 weekends). This includes thicknessing/sawing/shaping all the parts, dovetailing, and fitting. The gaps between the drawers will be sorted out once all are done. There will be 1/16"...

    Last Post By: Derek Cohen Today, 2:18 AM Go to last post
  • Michael Kowalczyk

    There is no available content written by Michael Kowalczyk