• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Kees Heiden

    Distressing

    Thread Starter: Kees Heiden

    Probably sacrilege to some, but how about distessing some projects? I really like antiques, I also like to build furniture, but I don't like antique reproductions that look like new. So untill now I have mostly made contemporary looking furniture and I have bought some antique stuff. But for an...

    Last Post By: Chris Fournier Yesterday, 11:51 PM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Chris Padilla Yesterday, 10:07 PM Go to last post
    ian maybury

    Heat damage to blades when grinding...

    Thread Starter: ian maybury

    Brian's thread on choice of chisels just set me thinking. I'd always thought it was just that I was using cheap chisels, but it starts to look like even good quality chisels sail pretty close to the wind so far as edge damage is concerned when working hardwoods. My white steels don't much like...

    Last Post By: Chris Fournier Today, 12:03 AM Go to last post
    Stuart Welsh

    Your High School shop from the 70's.

    Thread Starter: Stuart Welsh

    Did you take shop class in the 70's in either Junior High or High School? If so what to do you recall about the shop? The reason I ask is as I complete my shop I'm taking the time to make it look as close as I can to what a shop from that era would have looked like, it's an homage to the first...

    Last Post By: Rod Williamson Yesterday, 3:26 PM Go to last post
    Bruce Page

    What goes into a $3m wristwatch?

    Thread Starter: Bruce Page

    Patek Philippe 5175R Grandmaster Chime Watch Long but very well done. The choir music is a little over the top.

    Last Post By: Shawn Pachlhofer Today, 12:16 AM Go to last post
    Nathan Duricek

    American Flag cutting board

    Thread Starter: Nathan Duricek

    Hey guys, I'm looking to make a cutting board for some friends that were just married and I'd like to do it as an American flag. I've got the idea that I'll use Ash or Oak for the white. But what woods could/have people used for the blue & reds. I can't use stains, right? Thanks in advance!

    Last Post By: keith micinski Yesterday, 6:50 PM Go to last post
  • Sam Murdoch

    There is no available content written by Sam Murdoch