• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Joe Flores

    WARNING concerning Access Used Lasers

    Thread Starter: Joe Flores

    Hello all just want to tell you about a problem I am having with Access Used Lasers. They sold my laser per an agreement we had. Received $6000.00 deposit. After they sold the laser they did not pay me the last $6000.00. Now they are not answering my phone calls. I trusted Robert now it looks like...

    Last Post By: Scott Shepherd Yesterday, 9:39 AM Go to last post
    Rich Riddle

    Pick your NCAA Basketball team.....

    Thread Starter: Rich Riddle

    I moved to Kentucky but am married to a woman who loves UK. I like Kentucky as a place quite a bit, so for whatever reason guess they are my team this year, reluctantly. What about you folks?

    Last Post By: Rich Riddle Today, 6:54 AM Go to last post
    mreza Salav

    Cabinets, and lots of them...

    Thread Starter: mreza Salav

    As some of you now it's over a year and a half that I'm busy with building several things for a house we are building for ourselves. The main thread of that has moved here: ...

    Last Post By: Peter Quinn Yesterday, 4:48 PM Go to last post
    Mike Holbrook

    Calipers, Digital Dial?

    Thread Starter: Mike Holbrook

    The chair making classes I have taken so far have tested round straight and tapered tenons for correct size with a ruler or simple mechanical calipers. I had a hard time telling how much more needed to be removed by trying to fit a mechanical caliper over the tenons I was turning on a lathe. There...

    Last Post By: Curt Harms Today, 8:14 AM Go to last post
    Julie Moriarty

    Conduit Bending 101

    Thread Starter: Julie Moriarty

    Since many here want to install conduit in their workshops, I thought I'd get a conduit bending workshop going here. The only damage you can do is too the pipe, and maybe your ego. ;) Of course, you need to have designed the system correctly. We can do that in another thread, if there's an...

    Last Post By: Julie Moriarty Yesterday, 8:38 PM Go to last post
    carl mesaros

    Lathe mass?

    Thread Starter: carl mesaros

    I have been reading with great interest the ongoing discussion about the new Grizzly GO766 lathe. I currently am turning on a Jet 1642 and have been considering moving up to a lathe with more swing and additional power and more mass. So I started to compare specifications for several lathes,...

    Last Post By: Roger Chandler Yesterday, 2:27 PM Go to last post
  • Jim Becker

    There is no available content written by Jim Becker