• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Keith Outten

    FreeStuff Drawing - Premium Woodturning Set

    Thread Starter: Keith Outten

    FreeStuff Drawing from Carter and Son Toolworks The name of the winner of this drawing will be announced on February 11th, 2016 Premium Woodturning Set Includes: 5/8" Bowl gouge: Incredibly strong and sharp, our 5/8" Bowl Gouge offers an enhanced bowl turning experience. Made of M42...

    Last Post By: David Nelson1 Today, 10:03 AM Go to last post
    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: Keith Pleas Today, 12:41 PM Go to last post
    Prashun Patel

    Walnut Cabinet

    Thread Starter: Prashun Patel

    Caveat: I'm not doing this entirely by hand, but since my dovetailing is largely manual, I figured it's fair. I'm making a small walnut cabinet and started dovetailing the carcass today. I finally started using the 'blue painters tape' trick to mark my pins. On this dark wood, I can finally...

    Last Post By: Brian Holcombe Today, 10:12 AM Go to last post
    Lasse Hilbrandt

    Which smoothing plane

    Thread Starter: Lasse Hilbrandt

    I know this must be a topic which has been discussed to death over and over again. Nevertheless I need some piece of advise on which smoothing plane to buy. I have Stanley no 7, a LN no 5, and Stanley no. 4. Im not really using the Stanley 4. I find it a bit bulky. I think I need an alround...

    Last Post By: Jim Koepke Today, 1:57 PM Go to last post
    Brian Holcombe

    Medicine Cabinets - Build thread

    Thread Starter: Brian Holcombe

    Evening! Building a pair of medicine cabinets for my house to replace some real junkers installed by the original builder. These will set into the wall and reveal about 2" of the cabinet. This first cabinet is the prototype, so there will be limited photos of the process, but the second one...

    Last Post By: Brian Holcombe Yesterday, 10:07 PM Go to last post
    Jeffrey Ruzicka

    Full Spectrum Lasers

    Thread Starter: Jeffrey Ruzicka

    I'm looking for a laser to get into this with as a hobby/small business and someone suggested Full Spectrum Lasers 40w hobby laser. I'm wondering, does anyone have experience with these or other FS Lasers? Would this a good route to take or something like this be very limiting? Any suggestions...

    Last Post By: Bert Kemp Today, 11:36 AM Go to last post
  • Jim Becker

    There is no available content written by Jim Becker