• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    randall rosenthal

    "old money"

    Thread Starter: randall rosenthal

    i started this piece on january 15th. i have diligently recorded the process. i hope you enjoy watching this come together. i'll post a few photos over time. it starts with me gluing three pieces of white pine to make one solid block........

    Last Post By: randall rosenthal Today, 9:37 AM Go to last post
    ian maybury

    Heat damage to blades when grinding...

    Thread Starter: ian maybury

    Brian's thread on choice of chisels just set me thinking. I'd always thought it was just that I was using cheap chisels, but it starts to look like even good quality chisels sail pretty close to the wind so far as edge damage is concerned when working hardwoods. My white steels don't much like...

    Last Post By: ian maybury Today, 4:32 PM Go to last post
    Frederick Skelly

    Safety poll: Do you use the guard on your tablesaw?

    Thread Starter: Frederick Skelly

    It will seem nuts to some of you, but Ive never used a tablesaw that has a guard. Every one has always been just "bare blade". I occasionally use a home made splitter. Im thinking its time to mend my ways before I get hurt and have to mend my hand. But I got curious and wanted to poll the community...

    Last Post By: Jim Becker Today, 5:44 PM Go to last post
    Gilbert Grenier

    I'm spending 10K - are those the right choices?

    Thread Starter: Gilbert Grenier

    Hello all, I've been reading a lot of threads about a lot of topics, but always in the shadow. Today I'm jumping in with the results of my inquiries. But first some backgroud info... (By the way I apologize if my english writing is not very good, I'm french canadian and I never really took...

    Last Post By: Rod Sheridan Today, 5:47 PM Go to last post
    Prashun Patel

    Slab table jointing help

    Thread Starter: Prashun Patel

    I am making a dining room table from two slabs. These are 110" long. Lacking a straight edge that long, I made one long enough to cut with my circular saw, reasonably straight. I am trying to joint the edge now by hand. I'm using a Veritas BU jointer with an edge guide. It's made getting the...

    Last Post By: Kent A Bathurst Today, 1:48 PM Go to last post
    Jeff Wittrock

    Saw nib

    Thread Starter: Jeff Wittrock

    I just bought some 1095 blue spring steel and have been planing on making a panel saw. This evening I was looking at images of some older saws for ideas when my wife walked in and started lookin at them. My wife is not really interested in woodworking. Sometimes she will try one of my tools...

    Last Post By: george wilson Yesterday, 7:43 PM Go to last post
  • Jim Becker

    There is no available content written by Jim Becker