• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jerome Stanek

    Glowforge release

    Thread Starter: Jerome Stanek

    I was wondering if Glowforge has sent out any units yet. I thought they were supposed to release the middle of December.

    Last Post By: Kev Williams Today, 3:02 AM Go to last post
    Eric Schubert

    My First Workbench Build - A Journal

    Thread Starter: Eric Schubert

    Welcome to my journal thread for my very first major build: a workbench! I plan to add photos and updates as I make progress on the bench build, which may or may not be frequently. It all depends on how it plays out. But, I'm hoping that it'll be a learning experience for both you and me, and...

    Last Post By: Eric Schubert Today, 2:58 AM Go to last post
    Patrick Chase

    Ruler trick example

    Thread Starter: Patrick Chase

    This is a tangent from Stewie's "stone flattening" thread, particularly the assertion that ruler-tricking is used as a substitute for flattening the back of an iron. Here's an example of ruler-tricking done as Charlesworth recommends (a quickie snap of the iron from my L-N 8). Note the...

    Last Post By: Devon Curtis Yesterday, 5:39 PM Go to last post
    Bert Kemp

    Tire air Pressure

    Thread Starter: Bert Kemp

    I was going to bring this up in the oil check thread but decided to start a new one for what I think is far more critical then checking oil and thats checking your tires air pressure. Its more troublesome to check 4 tires for air but way more important from a safety point. I think low air pressure...

    Last Post By: Mike Henderson Yesterday, 9:10 PM Go to last post
    Jim Becker

    Project: Buffet/Hutch - Completed

    Thread Starter: Jim Becker

    In our home, we have a large, great-room with a story and a half lofted ceiling with barn beams and a walk-in fireplace in the middle of the long wall. One end of the room is a sitting area and the other is our "formal" dining area. A project that's been on "my list" for a very long time has been a...

    Last Post By: Guy Dotan Yesterday, 11:13 PM Go to last post
    Dave Macy

    Still struggling with G0555 tension now w/ pics

    Thread Starter: Dave Macy

    I continue to struggle getting any tension on my G0555 that we bought used. Here's where I'm at. I'd bought a 3/4 bladerunner from Iturra, but yes, I also have a 1/2" too. It makes no difference right now. I took out the old tension rod, ran it through a die to make sure the threads were...

    Last Post By: Geoff Crimmins Yesterday, 10:32 PM Go to last post
  • James Rambo

    There is no available content written by James Rambo