• Mike Heidrick

    There is no available content written by Mike Heidrick
  • Recent Polls

  • Recent Forum Posts

    ken hatch

    A New Toy

    Thanks Graham, that was good for a laugh. I don't have a fine India but I expect the results wouldn't be much different that those from a hard Ark or

    ken hatch Today, 12:03 AM Go to last post
    Stew Denton

    Hand tool finds, 5/20/2017

    Mike,

    I think your Nicholson is a prefect choice for conversion. As mentioned above, I dearly love my 7 point rip, and on lots of occasions

    Stew Denton Yesterday, 11:58 PM Go to last post
    ken hatch

    Dovetail Guide comparison

    Allen;

    To somewhat answer your question. I've tested the LV guide but not the DB one. While I found the guide for the most part works as

    ken hatch Yesterday, 11:57 PM Go to last post
    Phillip Gregory

    Building a Mr Sawdust table - materials

    I used generic Unistrut to make the table support for my DeWalt GE. I put two nuts and two washers between the base flanges and the bottom of the strut

    Phillip Gregory Yesterday, 11:55 PM Go to last post
    Phillip Gregory

    shaper insert tooling question

    A molder is probably the best piece of equipment for doing what you intend to do. They can run much wider profiles than your shaper and have built in

    Phillip Gregory Yesterday, 11:21 PM Go to last post
  • Recent Blog Posts