• Scott Perry

    There is no available content written by Scott Perry
  • Recent Polls

    Spending more or less this holiday season? (Votes: 56)

    1. Spending quite a bit more (Votes: 7)

    2. Spending a little bit more (Votes: 6)

    3. Spending about same as last year (Votes: 28)

    4. Spending a little less (Votes: 7)

    5. Spending quite a bit less (Votes: 8)

  • Recent Forum Posts

    Ryan Baker

    Proper hand screw torque

    I like Joshua's method the best.

    I don't crank down on things with all my might, but I suppose I tend more toward the "tight" side

    Ryan Baker Today, 8:04 PM Go to last post
    Art Swander

    Hammer Handle Pen & Stand

    If you have a small photo of him, you could get a local engraver who does Dye Sublimation to sublimate a photo on say a 1" x 1" or so FRP Plate

    Art Swander Today, 8:02 PM Go to last post
    Brian W Smith

    Shop Design Reflection

    George,looking at your location/s....just a guess,would say you're traveling pretty much past our neighborhood.You and if it apply's,the wife should stop

    Brian W Smith Today, 8:02 PM Go to last post
    Derek Cohen

    Making a 1/4" chisel 3/16"

    Daniel, you will grow old and grey attempting to remove 1/16" with a file or a diamond stone. And it is not so easy to end up with the square or

    Derek Cohen Today, 7:57 PM Go to last post
    Art Swander

    Jet 1440VS Lathe

    It is a Reeves Drive. Just played with one yesterday....

    Art Swander Today, 7:55 PM Go to last post
  • Recent Blog Posts