• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Rich Riddle

    Why Not Convert to Metric?

    Thread Starter: Rich Riddle

    I have a Hammer slider with a metric system installed on the fence. It's actually a much easier way to cut things and even build. Why haven't we simply adopted the metric system in the USA? It would prove much easier to figure fractions for those folks who are fraction challenged.

    Last Post By: Jim Koepke Today, 1:41 PM Go to last post
    george wilson

    Why don't you use ceramic stones?

    Thread Starter: george wilson

    Maybe I got lucky. My flattening of the White stone took about an hour,using a used diamond stone. It was slightly out of flat,and had a fuzzy spot of ceramic that had to go. I have seen pictures of "sawn" looking ceramic stones by Spyderco(my brand),but haven't encountered one personally. I got...

    Last Post By: Reinis Kanders Today, 6:24 PM Go to last post
    Christopher Charles

    Is the Klausz-Frid-Scand Bench Dead?

    Thread Starter: Christopher Charles

    Hello all, Someone noted that everybody loves a thread on building a bench (just like you can't have too many clamps?). I'm planning to migrate this thread to SMC: http:// forums.finewoodworking.com/fi...and-bench-dead (Remove the space after // when copying into your browser.) I'll...

    Last Post By: Christopher Charles Today, 5:58 PM Go to last post
    Rich Engelhardt

    Freehand curve cut on a tablesaw?

    Thread Starter: Rich Engelhardt

    http://www.thisoldhouse.com/toh/video/0,,20924478,00.html Tom Silva's using the table saw to freehand cut @ 57 seconds into the video. I'd think this is a good way to be force fed a piece of material - - but - - this is TOH & Tom Silva.....:confused::confused:

    Last Post By: John Blazy Today, 9:55 AM Go to last post
    Todd Burch

    Building my inventory of logs

    Thread Starter: Todd Burch

    I picked up a couple shorter water oak logs (red oak family) over the weekend. I'm collecting logs, so when I get a mill, I'll be ready. ;) These two logs are ~36" diameter (one 36 @ small end, one at the big end). They are 6.5' - 7' long. Log was too heavy to even move when a full 13.5' long....

    Last Post By: Todd Burch Today, 2:37 PM Go to last post
    David Falkner

    2nd Build (first) - CNC Router

    Thread Starter: David Falkner

    Building my 2nd CNC first, I hope. I have been researching for over a year, read a thousand threads and articles, and am hopefully building my 'second machine' for my first. There is still a ton to learn and that process will probably never stop. Of this I am certain, I will be in new territory...

    Last Post By: David Falkner Today, 8:26 AM Go to last post
  • Jared Walters

    There is no available content written by Jared Walters