Grant Wilkinson
Contributor

I preferred lexan when I made mine. It does scratch a bit easier than acylic, but it's tougher. If you go for acrylic, be sure to get cast, not...

I have an inexpensive Simonize model, sold in Canada by Canadian Tire. It does a decent job of foaming and rinsing the car, but does not compare to...

In Canada, you need to be careful about having too many cards. Even if you pay them off completely each month, they affect your credit rating. When...

Thank you. There are visible lines in the black background. I think I need to increase the lines per inch in my Lightburn settings. There are no...

Thanks much, Keith. Lots of learning to do, but a reasonable first effort, I think.

I burned this in Lightburn at 1500mm/mm and 60% power. All lasers will differ, though.