No Recent Activity

3 Visitor Messages

  1. Thanks again Jim, I appreciate you taking the time to pass on some of your knowledge! I started down the path of honing guide but think I need to just get on with free hand sharpening. while there maybe a steeper learning curve in the beginning, I think it will be a bigger benefit in the long run. I will check out some of the Paul Sellers tutorials.
  2. View Conversation
    I've got a 'fine' hard Arkansas and a Translucent Washita. I sharpen freehand the way we were taught by Paul Sellers to make a convex bevel.

    I strop with some green Chromium oxide at the end. I think stropping makes more difference than anything else.

    I think the first 'grind' step makes or breaks an edge, if you're not raising a burr in the first step - all the others will take too long.
  3. View Conversation
    Please excuse the PM, I now longer post on the public forum. I use a coarse diamond stone with my two oil stones, because I already owned one. The same can be achieved with a coarse synthetic oil stone, from Norton.

    You MUST raise a burr, at each grit, every time to maintain the desired cutting angle.

    Forming the wire burr illustrates that you've moved a layer of steel to a fine point.

    I follow Paul Sellers' method, but any repeatable process will work.

    Lastly, I found that the stones need to be at the height of my belt, or the cutting angle is too shallow.
Showing Visitor Messages 1 to 3 of 3
About Jeff Zihlman

Basic Information

About Jeff Zihlman
Location:
Iowa

Statistics


Total Posts
Total Posts
24
Posts Per Day
0.06
Visitor Messages
Total Messages
3
Most Recent Message
01-29-2017 9:17 PM
General Information
Last Activity
Today 10:33 AM
Join Date
10-21-2016