Ideas or opinions please... If you had a 100 watt laser that could burn at a speed 15-20 times faster than an "average" conventional laser(lets say a 50 to 60 watt Epilog or Universal) what products do you think would be able to take the most advantage of it's speed. There is one restriction. The active burn area is a maximum of 8" square. Actual piece size could be a maximum of 10" x 12". I have seen this run in person and it is FAST. I'm just exploring whether it would open enough new or lucrative doors to justify it's cost(several times the cost of the mentioned above). One thought is vector cutting parts etc.. Something I have never gotten into with my other lasers. Any comments would be greatly appreciated. John