Kevin Huffman
Member

Yes, I would look at the power supply going to the machine. Use a multimeter to test it. Ensure that it isn't shorting out or under/over voltaging. The spec's of the power supply should be written directly on the power supply itself.

I like to share a mallfunction in my laser tube
There was no laser output
Both epilog and coherent told me that the tube G50 is obsolete!!
The laser machine is dead
With no other choise left i disassembled the tube and was luky to find 2 bured capacitors - after replacment the machine refunctioned for some days and mallfunctioned again
this time i did find any bured part
I reassembeld the unit again and just of a sudden it functionagain for very short while
Now it is not operate any more

Any idea what can be done?
Do you have a G50 tube for sell?
Can any one handle this?
Can I install another/similar laser tube?

Thanks

I like to share a mallfunction in my laser tube
There was no laser output
Both epilog and coherent told me that the tube G50 is obsolete!!
The laser machine is dead
With no other choise left i disassembled the tube and was luky to find 2 bured capacitors - after replacment the machine refunctioned for some days and mallfunctioned again
this time i did find any bured part
I reassembeld the unit again and just of a sudden it functionagain for very short while
Now it is not operate any more

Any idea what can be done?
Do you have a G50 tube for sell?
Can any one handle this?
Can I install another/similar laser tube?

Thanks

Sorry Kevin my e-mail address is bryan.africatek@amap.co.za . I have never used any sort of message board like this so I am not familiar with how it works . Thank you . Please e-mail me .

Hi Kevin , My name is Bryan and I am from South Africa . I hope you are able to help me . I am in dire need of a repair manual for a Laser Pro Mercury M-25 as well as the older Mercury L-12 . Both machines are from GCC and as I understand your products are made by GCC so maybe you can help me . The local agents in SA will not suply these manuals to me . I need to order spares for the M-25 and I need this manual with the part numbers .

We don't have any info on doing mugs or round stuff on the rotary attachment. Is there something you could send me? Thanks alot.

What are you having an issue with?

Hi Kevin. I'm needing help with a pinnacle 25 watt laser that we just bought used. Would it be possible to receive some guidance from you? Thank you.