I don't think my abilities with sandpaper on cast iron would translate to being able to use a milling machine to acquire the same result. (Therefore...
Don't try fixing a problem when there may not be a problem to fix. The sole looks a little rough, clean it with some mineral spirits, rub some wax on...
There are a few ways to do this. One easy way is with a long piece of paper. Lay it out on a flat surface with a pin at either end. Hold the straight...
The use of a bevel up versus bevel down plane will not be much different. The biggest difference will be dealing with the chip breaker. Though there...
I am disabled now after a Back Surgery failed after a work injury but I can work a few hours a week, just wish it was more..
Location:
REX, GA USA
Interests:
I like building Computers Metal and Wood Work
Occupation:
I worked as a Prototype Machinist, Tool and Die, Model Maker and Patern Maker for over 35 years not counting 4 years of Machinist Schools and serving an Apprentiship for 2 years..
Signature
aka rarebear - Hand Planes 101 - RexMill - The Resource