• Jim Ritter's Avatar
    01-23-2015, 9:25 PM
    Jim Ritter replied to a thread Bench Apron in Neanderthal Haven
    An apron would not work for me. I clamp down on the front of the bench way too often not to have that convenient edge. jim
    37 replies | 1376 view(s)
  • Jim Ritter's Avatar
    01-21-2015, 11:26 PM
    Jim Ritter replied to a thread It Spins! in Neanderthal Haven
    Winton the chain is easily adjusted to have the jaw parallel at full clamping tension. Once set there is little need to adjust unless you want to...
    20 replies | 1958 view(s)
  • Jim Ritter's Avatar
    01-20-2015, 9:03 AM
    I'm pretty sure it was for a screw type holdfast with a flat bar. The bar kept the screw upright. I've got some old catalogs, I'll take a look when I...
    20 replies | 961 view(s)
  • Jim Ritter's Avatar
    01-19-2015, 8:57 PM
    Definitely a replacement handle, I have a bunch of those handles around the shop. Just got a Bell System axe this summer. Also have a couple braces,...
    13 replies | 1482 view(s)
  • Jim Ritter's Avatar
    12-31-2014, 7:37 PM
    Any chance you can post a photo of the screw at the handle end? We might have some other ideas if we can see what you are working with. You got good...
    8 replies | 732 view(s)
No More Results
About Jim Ritter

Basic Information

About Jim Ritter
Location:
Long Island, NY
Occupation:
Boat builder

Signature


Ancora Yacht Service

Statistics


Total Posts
Total Posts
249
Posts Per Day
0.24
General Information
Last Activity
Today 10:00 AM
Join Date
03-18-2012