Does anyone know where I could get 1 inch wide miter bars for an old delta/rockwell 12/14 table saw? I will make my own if I have to
but I was hoping to try and find some that are aluminum or steel or alloy etc..
Printable View
Does anyone know where I could get 1 inch wide miter bars for an old delta/rockwell 12/14 table saw? I will make my own if I have to
but I was hoping to try and find some that are aluminum or steel or alloy etc..
Use round pins/rod instead of mitre bars made from the polyethylene or similar material bread boards are made from. You can even offset the fixing hole to set the sled parallel to the blade as needed.
When I set up the fence I found a 1 2 3 block fit perfect in the slot. I would think about Aluminum or wood for weight reasons. I have the cast iron mire gauge and it weighs a lot!
Bill D
Thank you, I would not have thought of that.Quote:
Originally Posted by Chris Parks
Fascinating. I have a set of 123 blocks, as soon as I get home from work I have to try that.Quote:
Originally Posted by Bill Dufour
I should have said I was using them to hold a DI to adjust the table top so the slot was parallel to the blade. Then the fence to the slot.
I just adjusted the fence the other day because it did not lock down tight to the rail. Unfortunately on a unifence the lock down is also the fence parallel adjustment.
Big Mistake I used my 0.0001" Di. It has a much bigger dial and is easy to read from a distance. Made me chase it around ten times more then a 0.001 would.
BilL D
Check out 1018 cold rolled flat bar, 3/8 X 1 inch size. Four foot length from Metals Depot is about $25.