Printable View
I recently have been having an issue with a vertical line appearing in my etching see attached. Doesn't happen every time but from what I see it appears to jump. I'm using a Universal VLS4.60.
Any Ideas as to what this is?
Brad Raynor
Universal VLS4.60 60 Watt
Universal VLS4.75 75 Watt
Laguna EX 200 Watt
Quote:
Originally Posted by Brad Raynor
The glass is slipping on your rotary. You can see that it's moved away a step or so from the main body of the engraving. If you were to be able to shift it over, it would fit perfectly.
Thank you, I didn't think that could be it as it was happening on different glassware and growlers in the same place. I will double check that the glassware is more secure.
Brad Raynor
Universal VLS4.60 60 Watt
Universal VLS4.75 75 Watt
Laguna EX 200 Watt
If slippage is a problem, go buy some bathroom shower anti slip strips and cut to size to fit the ends of your rotaries.
They are cheap and work really well.
Hasn't happened recently. Must have been slipping.Quote:
Originally Posted by Paula Curtis
A test: if you have something you can use to test engrave the same image above: On screen, move the image an inch or so to the right, so 'the same place' also moves to the right in relation to the rotary's zero start point, so the entire engraving will be 1" farther right, requiring the rotary to move farther. Run a test engrave and hopefully the line will again happen...
IF the line still happens in the same place ON THE ENGRAVING itself, as in, thru the right-of-center portion of the 'n' and outer borders on the cup in your pic, then it's likely NOT a slippage problem, but a data issue of some sort...
BUT, if the line happens an inch farther left on the image, which in your pic would be approx between the 'c' and the 'o', that would tell you the problem is occurring in the same rotary-degrees-from-0-position, which would/should indicate some sort of mechanical issue, like a loose chuck/cone screw, etc...
but HOPEFULLY the problem doesn't happen again!
Thank you, I've been doing this for about 10 years, and I have had some items slip. This was happening periodically for a few days, and it appeared to be in the same area no matter what piece of glassware I had in the rotary. I will use your solution if it happened again.Quote:
Originally Posted by Kev Williams
Thx
-Brad