Oops! Wood is too small for the chuck.
I am about to make a whole lot of traveling communion sets. These include small chalices that can be made from 8/4 stock. The problem is, after buying the 8/4 stock, I realized I have 50mm (just under 2") jaws on my Nova G3 chuck. Too big for 1.75" wide stock.
What is the lowest cost solution? Could I glue extra wood on the base to make a tenon over 2"? What size jaws do I need if I buy new jaws? I don't want to spend between $140 and $200 on a new chuck and jaws.
Any other suggestions?
Ordered the 35mm Spigot jaws
Thank you all. I ordered the 35mm Spigot Jaws through Amazon. Until they come I will start on the plates (AKA "patens").