Across Grain cutting board in Planer a no no?
My cutting board will be dry in a few hours and after I square the ends it will be 13x17.5".
The 13" side is across grain and the 17.5" is with the grain.
I have a Ridgid 13" planer like the one below. It's a 2 knife setup. It's rare been used.
Can or should I pass this through the planer? Will it destroy the cutting board? I don't have a drum sander but can belt sand it or even use a router sled planer jig I made if the power planer will for sure cause problems.