MagicTouch on Acrylic/Glass with ODR Paper

I have a project which could justify going with the Magic Touch system. I'm looking to do full color on 3/4" acrylic or glass using the ODR paper. I've seen it a few times at the trade shows but I never trust what I see at the trade show.

Worth purchasing for that purpose or should I stick with outsourcing it with a direct to substrate printing?

Ross

I use ORD but not often. My results have been good but most of my projects have been smaller--4" x 6" or less and all have been on acrylic.

I recently had to buy a new laser printer for doing monochrome sublimation and I bought a new dye sub system (after swearing never again) so my need for CLT has all but disappeared. So I guess I would advise outsourcing.

Here is an example on 1/8" acrylic. No doubt will raise a few eyebrows about the logo.