2 Attachment(s)
Trotec laser will not engrave, only cut???
I recently bough an old Speedy from year 2000.
It is in fairly good condition and seem to work but I canīt output anything else from Corel but cutlines.
If I draw a square, make it a red hairline - No problem.
Job control works fins and laser cuts.
If I try to add a black square (engraving) and print it, the file in JC is all corrupted and shows up as a mostly black surface and engrave as such.
I am using printer drivers from a laser I sold years ago that was from 2005 and JC 6.5.4.
°Could it be the printer driver that is wrong, cut lines shows up correctly though!??
°I have tried every possible setting I can think of in Corel X4 with same result!
°The test files provided with JC engraves fine!
I have tried finding other drivers but I canīt find anything, anywhere online.
The laser is a 8003 C25 30W.
Very thankful for suggestions as I canīt think of anything else to try. :( :( :(
Here are some picture with job control in background for reference.
In this specific case the raster work is not all black in JC but still corrupted.
Attachment 372175Attachment 372174