Each time I fire it up is rewarding.
110 volt. single phase with an amperage draw measured in milli amps and a total lack of sawdust. What can it be?
It's my Cabinet Planner software. I can not recommend this product enough. Especially considering the low startup costs and the ease of use. I know that I made my money back on the first kitchen job I did. But I digress.
I was working on a project last night with a wrinkle that had me stumped. I sent Rob (the designer) an e-mail (about 6:30 EST) and got an answer back in under 10 minutes. This response time was nothing new either. He has been available just like that for the years I have been using his product.
If you are thinking about design software with cut sheet optimization capabilities, give Rob a jingle at www.cabinetplanner.com and tell him Ed sent you. You never know, maybe I'll get a T-shirt.
The usual disclaimer applies: I am not connected with or payed by Cabinet Planner. Just a very satisfied user.
Ed