Originally Posted by
Rick Potter
David,I was happy with it, until I swapped out all my sanders for newer models with dust fittings. Now I use my outfeed table to sand on, with a shop vac attached to the sanders. This works almost as well, except for dust that goes off the side of the work, which the table would catch.I was happy with the table, I just switched because of space. Note that mine was the smaller of two that Delta made, it was 1/2 HP. The larger had a bigger table by about 6" and a larger motor. If you find one, make sure the filter is in good shape, it is glued to the metal drawer, and I suspect is now made of unobtanium. You might check. I kept mine clean by vacuuming it out and blowing. Mine sold for $250, which is what I was asking.RP