5 Attachment(s)
I bought a vacuum system, have questions
I went to an estate sale and one of the things that I ended up with was a vacuum system. I have a Grizzly G0766 that I want to connect to. I’m missing something, but I’m not sure what.
The gauge and plumbing pieces were mounted on a board on the wall.what is the red thing for? I’m guessing a drain for condensation? What is the black tube for? What does it connect to?
Attachment 463050
The clear tubing went from the board to the “in” on the motor.
Attachment 463051
The tube from the “out” on the motor ends at the brass connector that looks like it’s supposed to connect to something else.
Attachment 463052
These chucks came with it. Unfortunately, they are threaded for 1x8 and my lathe has a 1 1/4” spindle. I’ll either try to adapt those or start over.
Attachment 463053
This is the outboard end of the spindle on my lathe.
Attachment 463054
How do I connect the tube from the motor to the lathe? Is there anything else I’m missing?
Thanks for any advice!
David