Engraving flat plates with text
Since installing the updated file, my memory errors have gone away,. but a new issue has shown up. I am engraving flat plates with text on them, quite large files and lots of characters and about 1/2 way through the cutting project the laser stops in mid stream and just sits there as if it has lost its direction. The center aiming laser is stuck at the point at which the laser stopped and does not return to center until the EZCad is shut down and restarted, but then I cannot continue from the point at which it stopped. Is this problem caused by the file update or is there another possible reason for this? The laser never did this until the new file was installed.