I have a 20+ year-old Craftsman 16" drill press on which I put a homemade 18" wide by 58" long 3/4" thick Birch plywood auxiliary table . It has a 1" by 3" oak stiffeners under the length of the front edge of the table to hold flatness. It's bolted to the drill press work table, so it rotates or goes up and down with the work table. I find it very convenient and helpful to use, and I normally leave it attached to the drill press. When I have to handle longer boards than can be supported by this tabletop I use one or two roller stands which I keep in the shop for general use.