1 Attachment(s)
Ripping small pieces on the TS
Today I needed to put a bevel on a small scrap in order to use it to support a photo on an aluminum plate. I found a small piece of Ipe that would work nicely, but running that small piece through the table saw required too much of a pucker factor. My push "stick" just wouldn't hold it against the fence. So I stuck a piece of double stick tape to the piece and found that now my push "stick" and the scrap were now one and I was able to rip the bevel with confidence that there would be no kickback. Although looking at the picture, I didn't position the foot of the stick at the rear of the piece, yet all went well.