It's sad to hear that folks have troubles with the short fence for those machines to hold accurate settings. The one I have (different brand) is rock solid and even indexed with detents for common angles including 90º.
Printable View
It's sad to hear that folks have troubles with the short fence for those machines to hold accurate settings. The one I have (different brand) is rock solid and even indexed with detents for common angles including 90º.
It’s been a busy fall. Here’s a lofting table in the shop basement, with the lines for a new whitewater dory.
Attachment 419409
and some Meranti hydrotek marine plywood I picked up in Denver.
Attachment 419411
I decided to keep my PM66, mainly for the long gunwale and chine rips plus maybe for dados.
Attachment 419412Attachment 419413
Very nice you were able to height match the PM66 to the slider...it fits in there great for both its own utility and for the very solid additional support surface it provides past the blade on the slider to the right. Nice arrangement!
Yeah, that is a work of art from a shop layout perspective. ive seen the same layout a few times in smaller pro shops. Usually the 66 has a power feeder. Im impressed by the tight tolerances you achieve with the stroke of the sliding table(looks very consistent in its parallel travel to the 66) and the height of both machines. Your floor must be in considerably better shape than my own!
I keep tossing and turning on the purchase of a wadkin pkf. I need a third table saw in a 800 sqft shop like i need a hole in my head, but i could fit it in the outfeed of my KF700 like you did and i really wouldnt lose much space. I have a power feeder and tilting bracket on my machine, however.
Hi Jon, just followed your build from start to finish, shop looks fantastic!
Giving me some great ideas for my coming build.
Thanks for sharing!
Thanks Jay for you kind comments. I’ve gotten a lot of great ideas and advice here.
A few pictures of shop in action with a dory I’m building:
Attachment 428909Attachment 428911Attachment 428912Attachment 428913Attachment 428914Attachment 428914
Owner looks quite pleased! :D
Owner trying not to fall off. :)
Jon — I assume you cut down the rails and the support table to the right of the blade on your PM66 to make it fit in that spot? How much rip capacity did you end up with in that config? It’s a great shop and layout.
Yes I did cut down the rails and table. I haven’t measured but I’m guessing it’s still around 36” or so. I do all wide rips on the slider. The cabinet saw is for long narrow rips of gunwhale and chine stock. Plus dados. Thx.
Jon at this point you could finish by yourself if necessary as all the tasks can be handled solo, though you may need to have the electrical roughed in. What will the interior walls be and the ceiling?