Originally Posted by
Scott Shepherd
Jack, that start line is because it's moving when it's cutting. You might have too much heat in it. It's hard to explain, but once you see it happen, it'll make sense. When you put a lot of heat into some materials, they want to really move around. As it gets closer to the end of the cut, it shifts around in the kerf and causes that mismatch. What speed/power did you use to cut through it? I was cutting some acrylic the other day and watched it actually move the material 1/8" when I was cutting it, while the acrylic was moving around as it was cutting. There are techniques to deal with it all.