Printable View
I recently got the original Jessem miter gauge but it’s missing the parts on the miter bar that allow it to snug up to the miter slot. Jessem no longer has parts for it, so I was hoping someone could show me what’s there and how it works so I can try to fabricate some. Thanks!
Anybody?….
Maybe post a picture of the bar you have.
This is what I’m asking about.
I have one, I think. I’ve had it for a long time. Could you post a picture of the whole thing? Mine has a sort of complicated system of pins.
Here’s a pic of the whole miter gauge.
My guess is there is a plastic or brass piece missing from the elongated slot on the side which gets pushed out by a cam to snug up the bar in the slot when you turn the screw on top. If so you might be able to make a replacement from a plastic cutting board. Maybe Roger can confirm if he has one.
Yes I’m thinking the same. Maybe I’ll 3D print some replacements and see how it goes. Use some small threaded inserts for the two screws, which I assume lock it into position.
Don't know if this will help, but found an online manual for your miter gauge. https://archive.org/details/manualzi...ge/n1/mode/2up. Also can see a bit of the adjusters on one of the images from this e-bay listing, https://www.ebay.com/itm/26663711692...Bk9SR5yDnoGqYw
Good luck.
Clint
Here’s my miter gauge. It’s the same as yours except for the blue cam clamps. I was nibbling out a half lap joint using a stacked dado head and didn’t realism that the red extrusion was loose. I caused a brake fire on my SawStop. New brake. New stacked dado set. It was my mistake but I wanted to make it more obvious when the extrusion is loose.
Attachment 514634
here’s what goes in that slot.
Attachment 514635
Attachment 514636Attachment 514637
Roger that is so helpful!! Thanks so much!
And a very good idea on the cam clamp!
Glad to help. A little more time now. The material looks like brass to me. The screws are unusual. They take a teeny little Allen wrench. The heads are very thin. I’ll try to get you more information.
notice from my dimensions that I can’t draw a straight line. I’ve had tremors nearly all my life. Recently, I ran across some of my work from a mechanical drawing class in college. I can see evidence of the tremors from 50 years ago. I was chastised in elementary school for my poor penmanship. Now I know why.
You could probably fit it with a piece of UHMW plastic and sand to fit.
The screws are unusual.
Attachment 514649
the head takes a 1/16” Allen wrench.
the letters YFS are stamped into the head. The S is hard to make out so I looked on the other screws and I’m pretty sure. If it turns out to be. 5, I’d be a bit surprised.
LIke I said, the brake fire was my fault. I kind of hated to abandon the very nice brass knobs but I hated replacing the stacked dado set and the brake more. I know the blue clashes a bit but that’s what I wanted. I want to be reminded.
I found a screw on MSC that might work. It looks like you would have to grind down the head about .010”.
https://www.mscdirect.com/product/details/48632871
bad news is that they are $1.00 each with a minimum order of 25.
Thanks Roger. I appreciate all your effort on this! I will check out the screw source as well as the local hardware store.
The first place I tried was Brownells. No joy. I figure that those screws are kind of a specialty thing. It’s going to be tough to find them.
Thanks to your help Roger it’s all fixed up and ready to use again.
I was happy to help.