I have shown this before during other threads. Just to stir up some conversation and hopefully provide some value I am posting it separately. I don't use this beast often but it hangs on pegs near the tablesaw and is handy now and again.
https://sawmillcreek.org/attachment....915426&thumb=1
When you need to cut larger panels the sled comes off the saw quite a bit. To make things less of a juggling act this support tongue is used.
https://sawmillcreek.org/attachment....915426&thumb=1
https://sawmillcreek.org/attachment....915436&thumb=1
I also have a piece of stock that is the same height as the sled base. A couple of rare earth magnets and some plastic dip smeared on for traction support larger panels that extend beyond the sled.
https://sawmillcreek.org/attachment....915436&thumb=1
https://sawmillcreek.org/attachment....915447&thumb=1
The whole affair looks like so.
https://sawmillcreek.org/attachment....915447&thumb=1
This makes nice, true, larger panel cuts a snap.
https://sawmillcreek.org/attachment....915465&thumb=1
I often do these cuts with a guided circ saw but I am doing multiple projects right now. There seems to be stuff everywhere. At any rate I get the panels I need and can carry on.
https://sawmillcreek.org/attachment....915465&thumb=1
It took longer to take the pics than it did to cut the panels https://sawmillcreek.org/images/smilies/wink.gif . My thought in posting is that this puts a large sled example in an easily searchable place for future or returning visitors.