Solution needed for cutting bevels on table top with proud breadboard ends
Just about finished the hall table Ive been working on for what seems like forever. The top is two boards edge glued, mortise and tenon breadboard ends, pinned with shop made dowels. Its the traditional breadboard design - three large tenons, only the center is glued (barely) and the center pin is glued. Outside pins are in elongated holes and not glued. Being February in NJ, I cut the breadboards a heavy 1/8th longer than the top is wide - assuming come summer the top will expand. So now the breadboard ends are about 1/16th proud on each side. I had originally planned to cut a bevel underneath the top all around. Now Im trying to figure how I can cut an even 13 degree or so bevel around all 4 edges of the top with the breadboards being proud as they are. It would be unsafe to put the top on edge and run it over the TS because only the edges of the breadboards would contact the TS top. And of course the width of the new edge would be uneven. Anyway I can think to do it would make an uneven edge. The only option I can think of is cutting the ends flush, but then come summer the top will likely be wider than the edges are long, which is something I don't want. Better planning on my part would have helped. Whats done is done. Any suggestions would be appreciated. Thanks
-Dan
