Originally Posted by
Dave Novak
Here's a picture that hopefully better explains what I'm doing. Each of the two sections is 1/2 the bar top. They'll join in the middle at the open ends forming a square hole that I'll fill with oak. The final length is about 134" and it will be roughly 30" wide. Each of the two half's will be glued up in two pieces, I'll use a plunge cut saw two rip them each 15" wide, then glue them together down the middle which unfortunately will be end grain to end grain, which is why I'm considering adding pocket hole screws to help hold it together over the long term. If you think my plan is flawed, please let me know. Might be a good excuse to buy a domino, but I just bought the TS 75/MFT3 combo so I'm a little short on funds. Thanks in advance!