Printable View
Greetings. New to the Creek. I am going to build a new bench. I have already been given a 30" x 84" bench top from a high school. Sanding this cleaned up nicely. I want to add a vise to the end. I was looking at Veritas Twin Screw vise. http://www.leevalley.com/wood/page.a...c41659&p=45114
Has anyone installed/used this? Would you buy it again.
Thanks
Victor
Hi Victor,
I use mine as a front vise.
http://i11.photobucket.com/albums/a1...3/103_0374.jpg
Although it works well, it can be finicky. Read the instructions, then read them again. When you've read them twice, read them again.:)
This vise will not suffer sloppy installation or poor planning- go slow. Don't forget to occasionally tighten the set screws also. I enjoy using this vise.
HTH
Mike
Victor, welcome to the Creek. Several members have the LV tail vise. It is very well thought of.
I use the LV on the front, too. Rarely need an end vise and then I manage with the little dohicky from LV that goes in a dog hole and screws tight against the work--ah yes, the Wonder Dog.
Apologies for hi-jacking the thread but I too have a question.
I have received my twinscrew from LV last week (after waiting 6 weeks - all takes a little longer here in Africa) It was sugested that I also take the extention plate but I desided not to do that (aditional cost) I now look at it and are not sure I made the right desision as the screws look like they are going to sit to close to one another.
What is the general view on this?
Morning Victor...Quote:
Originally Posted by Victor Stearns
I installed one several years ago on my current bench and every bench I have build for friends at their request since. It is very good in it's role as a vice with wide and even clamping between the screws. And with a little thought it can serve some multi-purpose roles other than just clamping stock that you are working on.
I rip large amounts of quite long stock (8'-14') on my TS that is set up strickly for ripping as cross-cut gets done on a SCMS with extentions. In order to do those lenghts safely in a one man operation, you have to have proper support or you have a potentially dangerous accident waiting to happen.
So.. my bench is positioned with the LV twin facing the TS front so I can get a little assist from that positive clamping effect of a Twin to provide support. It is a very versatile vise IMO, and if I could only have one vise it would be the vise I chose for that role.
Regards...
Sarge.. john thompson