Printable View
have a 3hp Unisaw that suddenly stopped working. When I push the switch to start, I hear the motor humming, but the motor doesn't start rotating. I can easily rotate blade by hand and see the belts rotating the motor pulley. Any ideas on what the problem is and what I would need to do in order to get saw working again?
Rick,
2 things can generally cause this:
1. The starting capacitor goes bad.
2. A lot of motors have a centrifugal switch. When the motor isn't turning, the starting capacitor is put in the circuit. Once power is applied and the motor gets up to speed, the starting capacitor is removed from the circuit.
What I have seen happen is sawdust gets into the centrifugal switch and prevents the contacts from closing properly. Thus the starting capacitor is never properly put in the circuit.
I have fixed this 2nd problem by removing the end cover of the motor and blowing it out with my air compressor air.
Thanks, I'll give 2. a try.
Rick, while you're looking at the switch, look at it from the other direction, also. Not only could the switch fail open preventing the start cap from being connected into the circuit, but it could also fail closed preventing the start cap from being removed from the circuit at the proper time.
If the second possibility is the case, and I have had that happen, you can kiss the start cap goodbye. They are almost always intermittent duty devices and being in the circuit continuously will destroy them in a very short time.
If you find that cleaning the switch doesn't cure the problem, you should be able to get a replacement capacitor at any local motor repair shop for a few bucks. Take the cap with you. It needs to be matched, not only for electrical size (mF and volts) but for physical size also.
I'd check all wire connections first.
Plug, inside the switch, and at the motor.
Unisaw motor hums but won't start.
Does it hum a pleasant tune, like "Singing in the rain" ? If so leave it alone and get another saw. I prefer a good melody to the roar of a TS any day.:D
I took one end cover off motor ( opposite pulley) and found just fan. There is another cover on the same end that is held by two nuts that come out from parallel to the motor. I didn't want to tackle taking these nuts off without checking to see if this is correct.
(note- I have 80's model unisaw model 34-802f)
Took cover off box on Unisaw were electrical wires come in and blew air all around. This solved problem and saw started mormally. Thanks for all input.
Rick You should check all of those connections, one must be a little loose. Steve
I'll check connections.
My saw was not starting-just humming. Found problem was start capacitor wire was broken. I took the capactior out to clean sawdust caked in the housing and now am not sure if it matters which of the two wires goes with the capacitor ends. Does it matter? ( one of the wires is gold).
Maybe it's humming because it doesn't know the words.
Sorry, couldn't resist! :D
Quote:
Originally Posted by Rick Cansler
Hi Rick, if there are only two wires, it doesn't matter which capacitor terminal you connect them to.Quote:
Originally Posted by Rick Cansler
The capacitor is non polarised.............Rod.
Just a note of caution. Don't forget that some caps will "store" a charge. You can get a rather sudden surprise from 'em. Used to be a standard prank to play on the newbie in the days of hard wired electronics.
Bill ;)
Depending on the type of capacitor the polarity can be important. I know electrolytic capacitor if reverse insert can be damaged, I am not sure what type of cap is used in this application.
Since the saw works on AC, there's no polarity on the cap.Quote:
Originally Posted by Mac Cambra
Mike
Thanks for the information on no polarity. I can't believe how much sawdust gets through the capacitor cover. It was caked with sawdust and with moisture in garage, not a good environment for the wires tips that slide over the ends of the capacitor.