While waiting for glue to dry, thought I'd try a first attempt at making a replacment chisel handle sans lathe. Grabbed a piece of 8/4 hard maple and cut a blank, planed it square and then planed down to 16 sides.
Printable View
While waiting for glue to dry, thought I'd try a first attempt at making a replacment chisel handle sans lathe. Grabbed a piece of 8/4 hard maple and cut a blank, planed it square and then planed down to 16 sides.
Starting at the taper end, I sawed a line at length to approximate depth. Using spokeshave, riflers, carving chisel got it to a pretty good fit.
Attachment 356588 Attachment 356589 Attachment 356590 Attachment 356591 Attachment 356592
Progressing up the handle, more apokeshave, rifflers, files, chisels, sandpaper and anything else I could find to shape the thing...
Attachment 356595
Attachment 356593 Attachment 356594 Attachment 356596 Attachment 356597
Not a perfect replica, but should be a decent user.
Nice job. I too lack a lathe. I've made a couple of cylindrical pieces using a similar technique as you. My results were less precise, but functional nonetheless. I was going for the "frontier look". (Sure, that's it :D)
Nice Job, Phil....I admire your patience, You made it happen without the lathe..I'm just learning how to turn as I have +20 socket chisel handles to make..But I'm learning and discovering its fun..BTW, the fit of the socket is the key step..Nice work, Phil.
That's how I did it. Nice job!
If you are not using a lathe, why make it round? Oval, octagonal, rounded edged triangular... all are good for various tools. I consider round to be a compromise shape that is not best in use, but is common because it's easily made on a lathe.
Must say again:Phil, you did a remarkable job considering no lathe,,,
Like you, I have no lathe. I made handles for two timber framing chisels. I made one round with shaves and sand paper. The other, I made hex shaped and rounded the edges a bit..
One is a socket and the other a tang chisel.
It's not difficult to do.
Thanks all. Yes, hexagonal or long cylindar would have been easier, but I was out to match the original handle as close as possible to match two others in this set. Just one of those lets see if I can do it project.
Jerry, your post on wood choice did inspire me to take a shot at this. And I must say if I was looking at 20 handles, I'd be searching for someone local with a lathe, or perhaps a mini lathe for the shop. I'm embarrased to say how many hours I ended up spending on this one handle. Good luck! Keep us posted.
Nice work Phil. It pays to work on those skills. There are many places in woodworking where hand shaping is required. I wish I was better at it. I keep trying.
Jim
Phil, as I was preparing for making my chisel handles , I stumbled on a You Tube video of a man doing it by hand (no lathe)..Cannot remember his name nor link..He also used spokeshave and drawknife....A tip for the future.