All depends on what it looks like inside of course but I'm hoping to get a couple round end tables, some cribbage boards with the side parts of the the burl and although I don't have a lot of experience in turning , maybe a couple bowls
Printable View
Finally got this cut into slabs. As we got close to the trunk it was pretty nice still so we made a couple more cuts and the entire thing is in slabs now.
I have it in my basement and will put some anchorseal on it in the next couple days and then stack and sticker outside. Here's a few pictures
Attachment 374082Attachment 374083Attachment 374084Attachment 374085
Unfortunately that does not show grain pattern that is reminiscent of a burl. More likely a scarred over section where a limb was.
I’ve encountered similar situations many times when milling.