Wondering about adding a Jessem Mast-R-Lift II to my BenchDog Pro Top Contractor
router table.
Jessem does sell the unit in the size needed (8 1/4 x 11 3/4), but I am not sure
whether the corner mounting holes in the Jessem top plate will match the ones in
the BenchDog supporting brackets. Has anyone tried this?
Thanks!
I went ahead and bought the Jessem lift (thanks to Amazon's free return policy). Turns out the lift's mounting holes do line up properly with the
support brackets in the Bench Dog ProTop contractor table. However, there is a small conflict
between the lift's spindle lock assembly and the support brackets. This was easy to fix by
hack sawing a thin relief into one of the brackets. So, all is good.