Printable View
I have a Delta 14 band saw with an extender. The distance between the two wheels is 31".
My old blade bent and I threw it away, thinking I had some replacements, but they are all too short.
So... I need some recommendations for where to buy a couple new blades, and how to figure out what size to buy? I guess I could just run the tape around and measure, but I figure you guys probably already know this answer... :)
Thanks for the help
ok... I think I figured it out... pi*D ( half a circumference on top, half on bottom) plus 2 of the 31's, one for each side...
so 3.14*14=43.974 ... so make it 44 plus 62 = 106
That sound about right?
ok... so much for being lazy... sorry to bother you... :) Guess I will do some readin...
I dealt with this with an old bandsaw and it was a bit of trial and error. Then you can bet I wrote that down many places! Do you have a model number anywhere? I believe most of the Delta's are essentially the same design for years, but I would imagine there is some variability and the riser makes it interesting. Sorry, not much help here, but I would see if you can find the exact model number and search from there.
A chart like this doesn't really help when you consider your riser block!
http://www.toolcenter.com/BBLADEFAQ.html
Depending on how old your saw is, this seems like a place to start:
http://www.old-woodworking-tools.net...-band-saw.html
Generally, the Delta 14" cast saws and its clones with a riser block use a 105" blade so you are in the ballpark but I might get a 105" blade so you don't tun out of tension ability.
[QUOTE=Dean Ousterhout;1579448]I have a Delta 14 band saw with an extender. The distance between the two wheels is 31".
My old blade bent and I threw it away, thinking I had some replacements, but they are all too short.
So... I need some recommendations for where to buy a couple new blades, and how to figure out what size to buy? I guess I could just run the tape around and measure, but I figure you guys probably already know this answer... :)
Thanks for the help[/QUO
Your blade will be 105" I have the same saw. I do a lot of resawing with mine. I use blade from highland hardware . The woodslicer is for resawing if you are doing that. Also do you do blade drift ?? If you don't what that is post back and i will explain good luck
thanks for the help.
Dan, it is a Rockwell Model 14 and not Delta. The serial plate has 25-203.
Van, I really like your "Lets talk bandsaw" thread... it is great. I looked at my saw and the tensioner looks to have lots of room, as in several inches to get smaller.
Del, I haven't used the saw much, although I have had it for quite a while. What is blade drift? as in for resawing? as in the thickness of the cut gets bigger or smaller? I haven't really tried any resawing... although I really want to :)
It is still 105" blade . Here watch this video on blade drift it will explane better than typing the info .http://www.youtube.com/watch?v=3OY3oKtssZkQuote:
Originally Posted by Dean Ousterhout
Hah.... very cool.... thanks for the tip Del...
Oops, wrong post.