How'd you get the Q4 for a little over $600 off of amazon.com? I've had my eye on one of these for quite some time, and it always seems to be $880 on amazon.
Type: Posts; User: Andrew McCarthy; Keyword(s):
How'd you get the Q4 for a little over $600 off of amazon.com? I've had my eye on one of these for quite some time, and it always seems to be $880 on amazon.
Thanks for the advice. I've got the TS 55, and Rich makes a very good point about being able to use the router with the aluminum track that I've already got. This makes my decision much easire. ...
I'm looking to buy my first plunge router. I've got a large fixed base router already, the porter cable 7518, and really need a plunge router. I might use it on my Leigh D4 in lieu of the larger...
I just purchased a Leigh D4, and am trying to decide between Whiteside and CMT dovetail router bits. What is everyone's recommendation as between the two? CMT has a set of 13 bits for about $171,...
Thanks for the advice everyone. It seems that there is a consensus that I should not try using the tablesaw to resaw a board, so I will try harder to find dimensioned lumber. I can appreciate the...
I am new to woodworking, and I just finished my first project, a router table. I purchased a 10" table saw for the job, so these are my only two pieces of equipment at the moment. I would like to...
I was looking at the ST5000, which is at www.converterstore.com/Step_Up_Down_Converters.htmAlso, what is the difference between a single phase transformer and a voltage converter, and why would one...
I have a 3 HP single phase Delta Unisaw, and I am going to be moving it to a jobsite in the next few weeks. There is no 220V service at the jobsite, only 110V. As a result, I am contemplating...