Search:

What is the difference between the 2 routers? The Kreg is about $100 more but is it worth it?

Thank you but did you mean to write 36in fence vs 37in fence? I actually ordered the ics base with the conversion kit last night for 328 from amazon. I will have to check out super cool tools.
...

Great tips. Thank you
Just wondering about a 52in fence...2 car garage so it gets crammed midway through an active project.

Will do. Thank you

Wow. I just completed setting it up and powered it up for the 1st time and it sounds so quiet and smooth. What a beautiful saw especially coming from a screaming job site saw. 100% worth it and now...

Will do thank you

wings came in the main box

I bit the bullet and bought the saw. It was clearly in the original packaging and I did an inventory per the user manual. All the parts except the fence and rails are there but I knew that going to...

That incra setup is nice. How much does that sell for new. I know you are selling the original setup and I will message you in private about it.

From what I understand looking at unboxing videos, it seems a complete basic sawstop PCS 175 comes in a minimum of 3 boxes, the saw, the rails, and the fence. It looks like all the small parts come...

The seller buys pallets of goods wholesale and resells them so not stolen. As far as defective, I would not know until I power it up

Is it worth buying a new in box saw stop pcs 1.75 hp from a private seller for $1200. It does not have the rails or fence so that would be an added expense. After looking at unboxing videos it seems...

I've seen the new ones as well but I'm not sure if the cyclone designs are the same. I'm sure it can work though

How would I know if it is good match? How can I tell if my Oneida cyclone would work with the 2 hp grizzly?

sure, I understand what you mean. You suggest using the grizzly because of the 1/2 hp larger motor and 3/4 in larger impeller?

I can detach the cyclone for sure but not sure how to attach it to the grizzly.

Thanks for the input

I recently bought a used 1-1/2HP Oneida dust collector with a built in cyclone and 12in impeller(stock photo attached since its an older model/style) . I also came across a used 2HP grizzly G1029Z2P...

Thanks. I will probably go 30amp and install 6in pipes. This way if I ever upgrade, it will be just a dust collector swap

Thank you. I may go 30amp for growth purposes since cost and time will be be pretty much the same anyway

motor specs
HP 1.5
RPM 3450
Volt 115/208-230
FLA 13.4/7.4-6.7
SF 1.30
SFA 17.6/10.3-8.8
phase 1 type b
thermally protected.

I assume there is no harm in installing 30amp dual pole breaker and 10 gauge wires since it would be the same amount of work anyway. Maybe I will be gifted with a 5 HP dust collector one day :)

Its been purchased. Now I have a couple of wiring questions. What size wiring and circuit breaker do I need to run if I had the motor wired for 220. It can also be wired for 110

motor specs
HP...

I went on to clearvue's site but I did not see anything for remotes or contactors. Could you send me a link?

Yes I am a one man 2 care garage diy shop. The motor does work and the photos are of the same model but not the one I am buying.