Search:

Type: Posts; User: Kelvin Penner; Keyword(s):

Search: Search took 0.00 seconds.

  1. You got some nice toys, nice space. Kelvin

    You got some nice toys, nice space.

    Kelvin
  2. sprecher schuh IP65 starter (on and off switch)

    My General table saw came with this starter, has worked fine for the last 10 years. Stop working so I opened the case and a I noticed that a wire came loose, I'm having problems trying to find where...
  3. Replies
    11
    Views
    15,899

    May first TS was a Rockwell 10 inch and I did...

    May first TS was a Rockwell 10 inch and I did some of my best work with it. It will do almost anything you want with it. For $150 it can be a steel, check condition and if in good shape, buy.
    ...
  4. Replies
    7
    Views
    1,379

    When it comes down to chop saw everyone has a...

    When it comes down to chop saw everyone has a different opinion. My co-worker has the 12" sliding Dewalt and loves it, for me I use the Hitachi 10” sliding compound. I’ve been a long user of...
  5. Work from the center. Measure the back wall and...

    Work from the center. Measure the back wall and find the center. Find the center of your shelve; make a mark front and back. Measure the back from the center and mark your shelve left and right....
  6. Replies
    6
    Views
    9,616

    Jim thanks The base is 20 3/4 by 20 3/4 with...

    Jim thanks

    The base is 20 3/4 by 20 3/4 with not much spare room.

    Thanks I'll check out Mikes

    Kelvin
  7. Replies
    6
    Views
    9,616

    Thanks Jim, David, John, I’ve picked up a...

    Thanks Jim, David, John,

    I’ve picked up a 43-431 with a fence for $925. The shaper has been sitting for some time, has some light surface rust and is missing wrenches. It comes with a mobile base...
  8. Replies
    6
    Views
    9,616

    Delta 43-431 Shaper

    Hi All,

    I need some help. I've been looking for a shaper and found a next to new Delta 43-431 complete with fence, mobile base and a few cutters for $1000.00. As you all know a new 43-495x is...
  9. Adam, I would not use a belt sander, you can...

    Adam,

    I would not use a belt sander, you can do more damage then good. Use a fresh router bit with a bearing, be careful to stay true, do not rock the router. You could also just use a sharp...
Results 1 to 9 of 9