On 11/20/10 I had a major brain freeze and ran a freshly sharpened 3/8" chisel into my wrist a severed an artery. fortunately I kept my cool and tied things off well enough to survive until the EMS...
Type: Posts; User: Ron Williams; Keyword(s):
On 11/20/10 I had a major brain freeze and ran a freshly sharpened 3/8" chisel into my wrist a severed an artery. fortunately I kept my cool and tied things off well enough to survive until the EMS...
Beautiful saw I would love to have one like it
The SPF is to soft for the top. Buy the 2X12's and rip them to size you will get better wood
Great Job. Would like to know who did the Hardware
Just purchased a bottle to be shared at My daughters wedding
After that I'm would like to tear out the existing exterior wall and create a 7'X 20' opening with 2 4X4 posts for support. The existing wall has a door and 4, 34"X72" windows in it. The roof...
I have the G9860ZX 12" Z Series Jointer w/ Spiral Cutter head and love it. I have had this machine this machine for 2 years and it continues to be pleasure to use.
I needed a good laugh
After using a Uni for 25 yrs I cut the end of my index finger off. I bought a Sawstop to replace the Uni. The purchase was as much for my 25 yr old son as for me. Its a great saw and came setup...
All of my dealings with Grizzly have been top notch. dont let a little delay cause you to miss out on owning what will be a very long term investment
[QUOTE=Chip Lindley;1025293]
As for arbitrarily replacing Unisaw pulleys, those are not hardware store items. And I doubt any machined steel pulleys would need replacing UNLESS they were loose on...
If you replace the bearings replace the pulleys while you are at it. I did not and had to disassemble and replace the pulleys later. I know this will not make any sense to some of you, the folks at...
I have the exactor mounted to the ceiling setup to rotate out of the way if needed
I own the G9860ZX and absolutely love it you will not regret buying this machine. I went from and 8" powermatic to the griz
I have a 15" Griz planer and a 12" jointer with the segmented spiral heads and I am completely satisfied with the way these machines cut. I ran some curly maple tis weekend with no problems at al
Mount it to the ceiling
This web site will have everything you need
http://www.sawcenter.com/index.html
We are currently finishing a large job with Mission style Trim all in Qtr Sawn White oak 180 will properly prep the wood for stain or your sanding sealer. We had the M.L. Campbell rep to come to the...
I am currently using The grizzly 12" Ultimate and a 15" Planer bought with The Spiral segmented heads. I also have an 8" Powermatic and a 13" rockwell Invicta Planer. The grizzly machines give me the...
I thought the same thing when I replaced the arbor on my Uni. with the new arbor and bearings I had a very small vibration. I replaced the pulleys and no more vibs. (The Saw Center recommends...
While your at it replace the pulleys
It appears that when the floor was sanded the floor had a greater moister content on the face side. I assume that the heat was on this winter and dried the floor causing the raised joints....
Check inside the switch box for 2 dials to adjust (Call Grizzly)
I have a 12" Grizz and had a similar problem it was resolved by adjusting 2 controls inside the switch housing
I have the Grizzly Head on a 12" Jointer and a 15" planer. they work great