My thinking was that the motor which is on the right side of the infeed side would rest over the cabinet and that would be where the pivot would be. The infeed would swing out to 90 degrees of the...
Type: Posts; User: Fred Renich; Keyword(s):
My thinking was that the motor which is on the right side of the infeed side would rest over the cabinet and that would be where the pivot would be. The infeed would swing out to 90 degrees of the...
You might try making a bench top that would be longer than the base length of the drum sander. One end would set on top of your cabinet and the other would have two legs with rotating castors. You...
The stain and polyurethane are Minwax products. Both are oil based and matched to each other. When I put the stain on and let it set for just a few minutes and then wiped off the excess. I suppose it...
I am refinishing a table top. The top was distressed so I sanded it with a belt sander and removed all the old finish and distress marks and got down to clean wood. I applied a Minwax stain to the...
Mike, I found the article and the description of the door build will really be helpful. I like the part of the insulation.
Thanks for the link Andy. the video is helpful even though my equipment is nothing like what he is running.
David, when you added the angle around your door did you caulk between the angle and the wood edges?
Thanks for the input. I hesitate to use plywood but will if I can't figure out a way to keep the door from warping. I intend to put a z bracing on one side to help stabilize it.
I have a outside shop door opening that is oversized—4X7 feet. I am thinking about building a custom board and batten door from kiln dried 2X6 fir and painting it. If I create a shiplap joint between...
This has really been a lot of help. My space size is a panhandle with the panhandle being about 9 feet square and the main area 18 feet by 18 feet. I am figuring on putting two 4 foot fixtures in...
I am in the process of remodeling part of a pole barn into a wood shop. My ceiling height in the middle will be about 9 1/2 feet high slopping down to about 7 1/2" on the outside walls. I will...
This is my first post.
I am currently working on turning part of a pole barn into a woodshop. My problem is that I don't have enough space to store a lot of lumber inside. I do have an area under an...