Please count me in
Thank you
Type: Posts; User: Ernie DeMartino; Keyword(s):
Please count me in
Thank you
Please count me in
Thank you
Please count me in
Thank you
Please count me in
Thank you
Please count me in
Thank you
Please count me in
Thank you
Please count me in
Thank you
Please count me in. Thanks!
Please count me in. Thanks!
Count me in as well, either is fine. Thank you
I would try EPS , always seems to work for me.
How about using MDF, its cheap
Thanks Alexa and Rodne. I found a connection off of the MPC that was loose. On my initial check I didn't see it until I removed the termination and the wire came out of the crimp. So far so good,...
Walt,
its a DSP, MPC6515. I think I need to replace. Not sure why I thought the PS was the issue.
Thanks
Ernie
While I was engraving earlier today, I noticed the laser continued to fire when I paused the machine. I had to turn the laser power off to get it to stop. I rebooted, tried again, this time I was...
Please Count me in.
Thank you
Please count me in.
Thank you
The project is indoors; basically Im mounting a hardwood plaque to the osb board. I plan on using oil based poly unless there is a better alternative.
Thank you
I am working on a customer project that requires a clear coat finish applied to OSB board. Im planning on using poly but I'm fairly sure the OSB will soak it up.
I'm wondering if I should apply a...
Please count me in as well.
Thank you.
We've had good luck with the agate slices from LaserSketch.
I had the same issue when my stinger arrived. Flatbed is the way to go. I got a price to rent a forklift- 500$ for the day, ended up using the flatbed only cost 100.
Good luck your going to have a...
John, I agree with you; should have pointed that out first.
My guess is that the file is corrupted; I had a similar issue with a corel file a while back. I copied the design into a new CDR file and the file ran as expected. Hopefully this helps.
Ernie
Let me know if you are unable to open.
Ernie