Search:

Guy......you have a Kitako 10? What all do you carve?

Mike

Thanks for the replies guys.

Rick I have bigger problems now than I thought. I went to the shop, oiled the line, only to feel and hear air blowing. The poly tubing on the machine is now breaking...

Again, thanks for the replies. This machine has actually seen very little use either from me or the company that had it before. Water is a likely hood and Rick you are correct, I have not oiled it...

Bryan not similar at all. Every time I had an interruption it was cause by noise getting into my limits or my limit wiring. Most of the time this was high frequency caused by vibration, or actual...

David, the payback for the job you do cannot be measured in any kind of measuring system the world may choose.

I have spent the last 2.5 yrs as my wife's primary care giver, and though at times...

Hi Rick,

Thanks for the reply. No I do not have an oiling system due to ignorance on my part.:( I bought this machine used, but it did not work right from day one and I have finally got tired of...

I own of of these machines, and for the most part like the way it works. I do however have a problem I need help with. It is pneumatic driven and I am not getting smooth motion into the bore, and it...

Bob I know nothing Wincnc or camaster, but if your photo of the sail fish shows what I think it shows, it could possibly be noise as well, though on my antique Digital Tool machine, if I get noise it...

Bob as already explained, lots of things can influence the final feedrate. Are you talking roughing or finishing? Most roughing cuts will be deeper than your finishing cut and therefore need to be a...

Hi Gene,

I used a pdf file from a man in France and then created a 3d model of the guitar, neck etc. I didn't follow the pdf exactly but close enough you are sure it looks like the original.
...

Nothing like most work here, but I love what I do. This is my first post. I cannot believe I just found this site yesterday. So far, love it.

Spalted Sycamore laminated 22 rimfire stock for...